Friday, September 17, 2010
How to avoid disk checking when comp. is switched on?
How to avoid disk checking when comp. is switched on?
If you are using any book of Windows before XP, this occur whenever Windows detects that it was shutdown inappropriately. You can either start shutting down your computer the correct passageway (going to Start --> Turn off/Shutdown), or just hit "cancel" whenever the disk check begin to load up.
u can basically skip it when it starts
but i dont think near is a way u can avoid since time
if windows requests to check your disk during bootup,it's becuse u didn't shutdown ur pc properly.it's best that u allow window to do it.also,next time,brand sure u shutdown properly
when,computer is switched on it will only show press any button to stop disk checking
http://support.microsoft.com/kb/831426/e...
Chkdsk.exe or Autochk.exe starts when you try to shut down or restart your computer
This is quantity of the registry change you will hold to make:
http://www.winguides.com/registry/displa...
Also, within is a service that runs under XP ( assuming you hold XP), and that needs to be shut down to brochure, probably not best to turn it off.
if your opertaing system is past windows xp and if respectively time you get disk checking you move about to start run and type msconfig in broad tab enable the remedy disable scandisk after bad shutdown
The best track to avoid disk checking is shutting down the system properly. To shut down the system always progress to START button and click SHUT DOWN and again select SHUT DOWN and click OK. You can also do so by pressing the windows push button on once present on the keyboard between Ctrl and Alt, and press U knob twice. Good luck
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment